Contact Us

TEL: +86-532-87237920
Fax: +86-532-87237920
E-mail: info@blowingplastics.com
Address: Site is located in the west of Taidong road and north of Xinjiang in Qingdao

Model ST-5000L Hollow Blow Molding Machine

Model ST-5000L Hollow Blow Molding Machine

Selection and principle of raw material for blow molding products: 1. Main raw materials: IBC composite medium bulk water container is one of the typical large plastic hollow packaging containers recognized by the market. The shape of the plastic content device is rectangular and the overall wall thickness is relatively thin (average about 2 mm), and the volume reaches about 5000 L .

Good quality various models hollow blow molding machine

Good quality various models hollow blow molding machine.jpg

产品描述_副本1.png

Selection and principle of raw material for blow molding products:

1. Main raw materials:

IBC composite medium bulk container is one of the typical large plastic hollow packaging containers recognized by the market. The shape of the plastic content device is rectangular and the overall wall thickness is relatively thin (average about 2 mm), and the volume reaches about 1000L. The transportation environment, the use environment and the interior are very special, so the production is added. The raw materials used by the workers have higher requirements in terms of mechanical properties, UV resistance, environmental stress cracking and corrosion resistance. IBC composite medium bulk container has become one of the most important international and domestic liquid transport containers because of its advantages of low carbon environmental protection, time-saving, efficient, high efficiency, high spatial utilization, and special functional requirements.

2. Introduction of raw materials for blowing water tanks

The blow molding water tank is a large full plastic hollow blow molding container, which refers to a single or multi layer plastic packaging container with a polyethylene resin formed by blow molding, with a length greater than a height, one or more liquid ports on the top, one or more discharge ports at the bottom of the end, and a volume between 500L and 20000L. As the volume of the polyethylene horizontal tank is large, it is often used in the outdoor, and is often used in the extremely bumpy road in the mountain area, so the product is demanding in the aspects of strength, anti ultraviolet, aging resistance and stress cracking. This requires that the raw materials used are comprehensive and good. Due to the scientific and strict management of raw materials, the products of suntop blow molding products have longer service life from the long-term feedback data from the market.

配图.png

Hot Tags: model st-5000l hollow blow molding machine, manufacturers, suppliers, wholesale, price, for sale
Inquiry